High Quality Low Noise Tripel Water Spraying LED High Speed Hand Pieces

DR-161 Dental LED High speed hand pieces

standard head / 2 hole/4 hole

LED Airotor HandpieceTech data:

LED Airotor Handpiece details:

After each patient use , maintenance should be done as follows:

1. First remove the diamond burs , and clean up all the teeth on dental handpieces precipitate

2. Use a metal needle to clean the spray holes and fumaroles

Note: The spray holes and diamond burs into 40 -degree angle , fumaroles and diamond burs to a 30 degree angle

3. Place the clean lubricating oil is sprayed into the axial hole 1-2 seconds ( diamond burs is plugged holes )

4. In the bottom of the handpiece were ( with / without quick connector ) two kinds of styling , make the right amount of lubricant is injected into the bottom

5. The handpiece with quick connector combination ( first determine the water switch is turned off )

6. Replace the diamond burs , surrounded by white silk cloth handpiece head ( make sure the needle does not touch the diamond burs and white gauze , so as not to tie )

7. pedal depressed for about 20 seconds , look at whether there is in white gauze on any stain. If there are stains on the white gauze , again, add oil , starting from item 4 continued routine maintenance , know that white gauze until no stain

8. Finally, no more than 135 degrees Celsius temperature and high pressure sterilization

Henan Dorit Biotechnology Co., Ltd. always takes “quality bearing responsibility, technology creating advantage, innovation leading the future ” as its development concept, and conscientiously implements to the operation, management, product research and development and manufacture.

During the process of serving global oral industry , Dorit takes every step as walking on the thin ice. We not only innovate bravely, but also go ahead steady step by step.